Search results for "Surface area"

showing 10 items of 203 documents

Properties of Nanosized Ferrite Powders and Sintered Materials Prepared by the Co-Precipitation Technology, Combined with the Spray-Drying Method

2016

Cobalt and nickel ferrites powders are synthesized by the co-precipitation technology, combined with the spray-drying method. The crystallite size, specific surface area (SSA), magnetic properties of synthesized products are investigated. All the synthesized ferrites are nanocrystalline single phase materials with crystallite size of 5-6 nm, the SSA of 80-85 m2/g and the calculated particle size of 13-15 nm. After spray-drying granules of the size up to 10 μm are obtained. After thermal treatment at 550 and 950 °C SSA decreases to 40-50 m2/g and 20-22 m2/g, respectively. The saturation magnetization at these temperatures increase from 17 to 40 emu/g for NiFe2O4 and from 51 to 77 emu/g for C…

010302 applied physicsMaterials scienceMechanical EngineeringMetallurgySintering02 engineering and technologyThermal treatment021001 nanoscience & nanotechnology01 natural sciencesNanocrystalline materialChemical engineeringMechanics of MaterialsSpray dryingSpecific surface area0103 physical sciencesFerrite (magnet)General Materials ScienceParticle sizeCrystallite0210 nano-technologyKey Engineering Materials
researchProduct

Synthesis of Eu<sup>2+</sup> and Dy<sup>3+</sup> Doped Strontium Aluminates and their Properties

2016

Strontium aluminate phosphors were synthesized by the solution combustion method using citric acid, urea or glycine as reducing agent and europium and dysprosium as dopants. The content of both dopants was in the range of 1 – 2 mol%. Dependence of phase composition, crystallite size and specific surface area on calcinations temperature, used reducing agents and dopants were determined. Luminescent properties of the calcinated at 1300 °C powders contained SrAl2O4 (90 %) and Sr4Al24O25 (10%) phases with crystallite size of 80 nm were determined.

010302 applied physicsStrontiumMaterials scienceReducing agentMechanical EngineeringInorganic chemistryStrontium aluminatechemistry.chemical_elementPhosphor02 engineering and technology021001 nanoscience & nanotechnology01 natural scienceschemistry.chemical_compoundchemistryMechanics of MaterialsSpecific surface area0103 physical sciencesDysprosiumGeneral Materials ScienceCrystallite0210 nano-technologyEuropiumKey Engineering Materials
researchProduct

Study of Mass Oxygen Transfer in a Biotrickling Filter for Air Pollution Control

2012

Biotrickling filtration is a potential and cost effective alternative for the treatment of volatile organic compound (VOC) emissions in air, so it is necessary to deepen into the key aspects of design and operation for the optimization of this technology. One of these factors is the oxygen mass transfer of the process. This study would facilitate the selection of the packing material and the mathematical modelling and simulation of bioreactors. Four plastic packing materials with a different specific surface area have been evaluated in terms of oxygen mass transfer. For the tested range of superficial liquid velocities, data show a relationship between the kLa and the superficial liquid vel…

0106 biological sciencesAir pollutionchemistry.chemical_elementBiotrickling filter010501 environmental sciencesmedicine.disease_cause01 natural sciencesOxygenlaw.inventionFilter (large eddy simulation)law010608 biotechnologySpecific surface areaMass transferBioreactormedicineMass transferVolatile organic compoundVolatile organic compoundsEngineering(all)Filtration0105 earth and related environmental scienceschemistry.chemical_classificationEnvironmental engineeringGeneral MedicineOxygenchemistryChemical engineering13. Climate actionMedi ambient DegradacióProcedia Engineering
researchProduct

Standardization proposal for the mapping of Caulerpa taxifolia expansion in the Mediterranean sea

1999

Fourteen years after the first observation of Caulerpa taxifolia (Valh) C. Agardh in the northwestern Mediterranean Sea, this green alga of tropical origin is now present in five countries (Spain, France, Monaco, Italy and Croatia). By the end of 1997, more than 46 km(2), at depths of between 0 and 50 m, were found to be affected by this expansion. A standardization of the cartographic procedure is proposed here. Such a standardization is necessary to compare maps produced by various organizations from different countries. For a given independent station, it is based on the definition of three levels of colonization:Level I refers to a station where one or several colonies less than 100 m a…

0106 biological sciencesCartographyCaulerpa taxifoliaMediterranean SeacartographieAquatic ScienceOceanography010603 evolutionary biology01 natural sciencesInvasive speciesSurface areaMediterranean seacartography; Caulerpa taxifolia; invasive species; Mediterranean seaMediterranean SeaColonization14. Life underwaterbiologyInvasive speciesEcology010604 marine biology & hydrobiologyUlvophyceaebiology.organism_classificationStandardizationGeographyMer MéditerranéePhysical geographyLevel iiLevel iiiStandardisationCaulerpa taxifoliaEspèces envahissantes
researchProduct

From Norway Spruce Bark to Carbon Foams : Characterization, and Applications

2020

Fresh bark from spruce Picea abies was milled and extracted with hot water. The extracts were purified in a number of steps in order to get tannin-extracts pure enough to prepare tannin-based carbon foams. The chemical composition of the extracts were analyzed. The foams were maturated and thermally treated to obtain desired properties, such as specific surface area, porosity, and compressive strength. It was possible to produce carbon foams even if they contained carbohydrate impurities. Differences in the properties of the carbon foams such as compressive strength, specific surface areas, and pore size distributions might be related to the compositions of the extracts. The foams were fina…

0106 biological sciencesbarkEnvironmental EngineeringMaterials sciencechemistry.chemical_elementBioengineeringThermal treatment01 natural scienceshuokoisuusAdsorptiontannins010608 biotechnologySpecific surface areaextractivescardiovascular diseasesbiomassa (teollisuus)PorosityWaste Management and DisposalChemical compositiontanniinitbiologybiomasspuunkuoricarbon foamsPicea abiesbiology.organism_classificationvaahdotCompressive strengthchemistryChemical engineeringuuttometsäkuusiadsorptioCarbonbiomateriaalitspruce
researchProduct

Experimental Investigation into the Effect of Pyrolysis on Chemical Forms of Heavy Metals in Sewage Sludge Biochar (SSB), with Brief Ecological Risk …

2021

Experimental investigations were carried out to study the effect of pyrolysis temperature on the characteristics, structure and total heavy metal contents of sewage sludge biochar (SSB). The changes in chemical forms of the heavy metals (Zn, Cu, Cr, Ni, Pb and Cd) caused by pyrolysis were analyzed, and the potential ecological risk of heavy metals in biochar (SSB) was evaluated. The conversion of sewage sludge into biochar by pyrolysis reduced the H/C and O/C ratios considerably, resulting in stronger carbonization and a higher degree of aromatic condensation in biochar. Measurement results showed that the pH and specific surface area of biochar increased as the pyrolysis temperature increa…

020209 energyecological risk assessment02 engineering and technology010501 environmental scienceslcsh:Technology01 natural sciencesArticleMetalSpecific surface areaBiochar0202 electrical engineering electronic engineering information engineeringGeneral Materials Sciencelcsh:Microscopyheavy metalslcsh:QC120-168.850105 earth and related environmental scienceslcsh:QH201-278.5sewage sludgelcsh:TCarbonizationChemistryBCR sequential extractionHeavy metalspyrolysisBioavailabilityVDP::Teknologi: 500lcsh:TA1-2040visual_artEnvironmental chemistryvisual_art.visual_art_mediumlcsh:Descriptive and experimental mechanicslcsh:Electrical engineering. Electronics. Nuclear engineeringlcsh:Engineering (General). Civil engineering (General)lcsh:TK1-9971PyrolysisSludgeMaterials
researchProduct

Characterization of the porous structure of Chilean volcanic soils by nitrogen adsorption and mercury porosimetry

2004

Pore volume, specific surface area (SSA), and total intragranular porosity (TIP) of Chilean soils derived from volcanic materials were studied. Soil samples involving the 0-15 and 15-30 cm depth of virgin and cultivated Collipulli (Ultisol) and Diguillin (Andisol) soils at two particle size fractions (<1 mm and <2 µm) were considered. From mercury porosimetry and N2 adsorption, mainly mesopores (pore diameter, dpore, about 10 nm) were determined for <1 mm Collipulli samples. Diguillin <1 mm soil shows macroporosity with dpore from 70 nm to 7000 nm. The clay fraction of Collipulli has macropores (dpore from 2000 nm to 40000 nm) and mesopores (dpore from 3 nm to 23 nm), while for Diguillin cl…

021110 strategic defence & security studiesMaterials scienceMacropore0211 other engineering and technologiesAnalytical chemistryMineralogy02 engineering and technologyGeneral ChemistryPorosimetry15. Life on land021001 nanoscience & nanotechnologyAndisol[SPI]Engineering Sciences [physics]AdsorptionSpecific surface areaKaolinite0210 nano-technologyAllophanePorosityComputingMilieux_MISCELLANEOUS
researchProduct

Monitoring B-cell repopulation after depletion therapy in neurologic patients.

2017

ObjectiveTo determine the factors that influence B-cell repopulation after B-cell depletion therapy in neurologic patients and derive recommendations for monitoring and dosing of patients.MethodsIn this study, we determined the association of body surface area (BSA; calculated by body weight and height with the Dubois formula), sex, pretreatment therapy, age, CSF data, and white blood cell counts with the risk and timing of B-cell repopulation, defined as 1% CD19+ cells (of total lymphocytes), following 87 B cell–depleting anti-CD20 treatment cycles of 45 neurologic patients (28 women; mean age ± SD, 44.5 ± 15.0 years).ResultsPatients with a larger BSA had a higher probability to reach 1% C…

0301 basic medicine40medicine.medical_specialty41132LymphocyteUrologyCD19Article03 medical and health sciences0302 clinical medicineWhite blood cellMedicineDosingAdverse effectB cellBody surface areabiologybusiness.industry14323030104 developmental biologymedicine.anatomical_structureNeurologybiology.proteinRepopulationNeurology (clinical)business030217 neurology & neurosurgeryNeurology(R) neuroimmunologyneuroinflammation
researchProduct

Therapeutic drug monitoring as a tool to optimize 5-FU-based chemotherapy in gastrointestinal cancer patients older than 75 years.

2019

Abstract Aims Most clinical trials exclude elderly people, leading to a limited understanding of the benefit-to-risk ratio in this population. Despite existing data regarding the oncological management of elderly receiving fluorouracil (5-FU)-based regimen, our objective was to investigate 5-FU exposure/toxicity relationship in patients ≥75 years and compare the effectiveness of 5-FU therapeutic drug monitoring between elderly and younger patients. Methods Hundred fifty-four patients (31 of whom are older than 75 years) with gastrointestinal cancers, who were to receive 5-FU–based regimens, were included in our study. At cycle 1 (C1), the 5-FU dose was calculated using patient's body surfac…

0301 basic medicineAdultMaleCancer Researchmedicine.medical_specialty[SDV]Life Sciences [q-bio]PopulationAntineoplastic Agents03 medical and health sciences0302 clinical medicineInternal medicinemedicineHumansGastrointestinal cancereducationAgedGastrointestinal NeoplasmsRetrospective StudiesBody surface areaAged 80 and overeducation.field_of_studymedicine.diagnostic_testDose-Response Relationship Drugbusiness.industryArea under the curveMiddle Agedmedicine.disease3. Good healthClinical trialRegimen030104 developmental biologyOncologyTolerabilityTherapeutic drug monitoring030220 oncology & carcinogenesisFemaleFluorouracilDrug MonitoringbusinessEuropean journal of cancer (Oxford, England : 1990)
researchProduct

Thermosensory mapping of skin wetness sensitivity across the body of young males and females at rest and following maximal incremental running

2019

Key points: Humans lack skin receptors for wetness (i.e. hygroreceptors), yet we present a remarkable wetness sensitivity. Afferent inputs from skin cold-sensitive thermoreceptors are key for sensing wetness; yet, it is unknown whether males and females differ in their wetness sensitivity across their body and whether high intensity exercise modulates this sensitivity. We mapped sensitivity to cold, neutral and warm wetness across five body regions and show that females are more sensitive to skin wetness than males, and that this difference is greater for cold than warm wetness sensitivity. We also show that a single bout of maximal exercise reduced the sensitivity to skin wetness (i.e. hyg…

0301 basic medicineAdultMaleHot TemperaturePhysiologyRestSensationPhysiologySensory systemBiologyWetnessRunning03 medical and health sciences0302 clinical medicineCutaneous receptorPhysical StimulationSkin Physiological PhenomenaSensationHumansThermosensingSensitivity (control systems)Skin wetnessExerciseSkinBody surface areaSex CharacteristicsFootThermoreceptorsCold Temperature030104 developmental biologyTouch PerceptionTouchThermoreceptorBody regionFemaleSexSkin Temperature030217 neurology & neurosurgeryBody Temperature Regulation
researchProduct